Vollrath E257 - Manual (Page 13)

5
Figure 7
Warning Label Locations - E257/F257
IMPORTANT NOTICE TO OPERATOR
BEFORE INSTALLING EQUIPMENT, READ THE OWNER'S MANUAL CAREFULLY. TAKE NOTE OF ALL INSTRUCTIONS AND CAUTION
DECALS ON THIS EQUIPMENT.
GO OVER THE MANUAL THOROUGHLY AND POINT OUT ALL DECALS TO YOUR EMPLOYEES, SO THEY UNDERSTAND HOW TO SAFELY
OPERATE THIS EQUIPMENT.
DO NOT REMOVE, DEFACE, OR PAINT OVER ANY DECALS. THEY ARE THERE FOR YOUR SAFETY.
CAUTION
„ „ „ „ „
„ „ „ „ „
THIS DEVICE MUST BE PLUGGED INTO A PROPERLY
GROUNDED RECEPTACLE TO PREVENT ELECTRICAL
SHOCK HAZARD.
TAMPERING WITH THE PLUG OR USING VOLTAGES OTHER
THAN THE SPECIFICATIONS ON I.D. PLATE WILL VOID
YOUR WARRANTY.
REFER TO OWNER'S MANUAL FOR INSTALLATION
I N S T R U C T I O N S.
723529
(Affixed to condenser shroud)
(Affixed to condenser shroud)
DANGER
ELECTRONIC SHOCK HAZARD
DISCONNECT FROM THE SOUCE OF
ELECTRICAL SUPPLY IN BUILDING
BEFORE SERICING UNIT
321105
HAZARDOUS MOVING PARTS
DO NOT OPERATE UNIT WITH OUTER
COVERING REMOVED
324107
CAUTION
THIS DEVICE MUST BE PLUGGED INTO
A GROUNDED RECEPTACLE TO
PREVENT SHOCK HAZARD.
324113
CAUTION