Lenovo ThinkServer TS440 User Manual
Page 147
• For the 3.5-inch hot-swap hard-disk-drive cage, install the four screws to secure the backplane on
the cage.
Figure 89. Installing the backplane for server models with 3.5-inch hard-disk-drive bays
• For the 2.5-inch hot-swap hard-disk-drive cage, install the six screws to secure the backplane on
the cage.
Figure 90. Installing the backplane for server models with 2.5-inch hard-disk-drive bays
Note: If you want to install the following backplane for server models with 2.5-inch hard-disk-drive
bays, ensure that the backplane is secured by the two tabs
1
. Then, install the three screws to
secure the backplane on the cage.
Figure 91. Installing the backplane for server models with 2.5-inch hard-disk-drive bays
Installing, removing, or replacing hardware
135