Lenovo ThinkPad 10 - Manual (Page 33)

Note: If you do not remove the smart card from your tablet after you eject the card from the Windows
operating system, the card can no longer be accessed. To access the card, you must remove it first,
then insert it again.
Using HDMI devices
Your tablet has a micro HDMI connector that you can use to connect an external display for video output.
To locate the micro HDMI connector, see “Tablet layout” on page 1.
To configure screen settings for the external display, do the following:
1. Swipe in from the right edge of the screen to display charms.
2. Tap the Devices charm.
3. Tap Project ➙ Second screen.
4. Tap to select a presentation scheme.
Using synchronization solutions
By using synchronization solutions, you can easily synchronize settings between your tablet and other
personal computer.
Synchronizing settings by using the Windows synchronization solution
To access Windows synchronization solution, do the following:
1. Swipe in from the right edge of the screen to display the charms.
2. Tap Settings ➙ Change PC settings.
3. In the navigation panel, tap SkyDrive ➙ Sync settings.
4. Configure settings as desired.
Using the GPS satellite receiver
Your tablet might have a global positioning system (GPS) satellite receiver that enables you to pinpoint your
location down to the street level. Use location-based applications to find your current location, get directions
to your destination, and find other location-based information.
Note: By default, the GPS satellite receiver is enabled. For a longer battery life, disable the GPS satellite
receiver when not in use.
To disable the GPS satellite receiver, do the following:
1. Swipe in from the right edge of the screen to display the charms.
2. Tap Settings ➙ Change PC settings.
3. In the navigation panel, tap Network ➙ Airplane mode.
4. In the GNSS section, slide the control to the left to disable the GPS satellite receiver.
Chapter 2 . Using your tablet 25