Liebherr K 2734 Comfort - Manual (Page 6)

Fig. 5
Fig. 6 On appliances with a freezer compartment
u Follow the sequence of the item numbers in the diagram.
Fig. 7
u Insert the spacer Fig. 7 (13) back under the right-hand side
of the door, as it is important for the stability of the appli-
ance.
WARNING
Risk of injury due to the door dropping out!
If the bearing parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What
is more, the door may not close and therefore the appliance
may fail to cool properly.
u Screw on the bearing brackets/bearing pins tightly (4 Nm).
u Check all of the screws and retighten if necessary.
4.4 Insertion into a row of kitchen units
Fig. 8
(1) Stack cabinet (3) Kitchen cabinet
(2) Appliance (4) Wall
The appliance can be inserted into a row of kitchen units. To
match the appliance Fig. 8 (2) to the height of the row of units,
a suitable stack cabinet Fig. 8 (1) can be fitted above the appli-
ance.
In conversions with kitchen cabinets (max depth. 580 mm) the
appliance can be installed directly next to the kitchen cabinet
Fig. 8 (3) . The appliance door will project 34 mm at the sides
and 50 mm in the centre in relation to the kitchen cabinet front.
This means that the appliance door can be freely opened and
closed.
Ventilation requirements:
- At the back of the stack cabinet there has to be a ventilation
duct of at least 50 mm depth throughout the width of the
stack cabinet.
- The ventilation space under the ceiling has to be at least
300 cm 2 .
- the larger the ventilation space, the more energy-saving the
appliance is in operation.
If the appliance is installed with the hinges next to a wall
Fig. 8 (4) , the distance between appliance and wall has to be at
least 40 mm. This corresponds to the projection of the handle
when the door is open.
Putting into operation
6 * Depending on model and options