English, Top and front panels, Power supply – Vitek VT-3479 BK User Manual

Page 6

Advertising
background image

ENGLISH

6

Top and front panels

1. VOLUME

- adjust volume level.

2. REMOTE

SENSOR

-remote control signal sensor

3. FUNCTION

SELECT

- select source of sound MP3/CD,
TAPE or RADIO, also the power off switch.

4. CD BACK (

)

CD: - Skip track backwards.

5. PLAY/PAUSE BUTTON (

)

- start or pause MP3/CD play

6. STOP

BUTTON

- stop CD playback; erase a CD program.

7. CD

NEXT(

)

CD: - Skip track forwards.

8. BAND SELECTOR (AM FM FM ST.)

- select AM/FM/FM ST. Waveband.

9. STEREO HEADPHONE JACK

- 3.5 mm stereo headphone jack.

10. TELESCOPIC ANTENNA

- to improve FM reception

11. TUNING CONTROL

- select AM/FM/FM ST. Stations.

12. BASS BUTTON

- enhances bass response

13. POWER BUTTON

- Switch the system on or to standby mode.

14. FM STEREO INDICATOR

- show the FM stereo indicator

15. CD DOOR
16. CD DOOR OPEN BUTTON

- press here to open/close the CD door.

17. LCD DISPLAY

- show the AM/FM dial frequency

- show the number of tracks

18. REPEAT BUTTON

- repeat a track CD/MP3 program

19. RANDOM BUTTON

CD: - play CD tracks in random order

20. CASSETTE RECORDER KEYS
PAUSE

KEY(

- interrupt recording or STOP/

EJECT KEYC

- stop the tape - open

the cassette compartment
F. FWD KEY (

-ativance the tape toward the

end).
F. REW KEY (

-Rewind the tape toward the

beginning.
PLAYKEY ( ) -start playback
RECORDER (

) - start recording

21. CASSETTE COMPARTMENT

-put into the cassette

22. AC MAINS

-inlet for power cord

23. BATTERY DOOR

-to open battery compartment.

Power Supply

Using AC Power
1. Check if the power voltage, as shown on the

type plate located on the bottom of the set,
corresponds to your local AC power supply.
If it does not, consult your dealer or service
centre.

2. Connect the power cord to the AC MAINS

inlet and the wall outlet. The power supply
is now connected and ready for use.

3. To switch off completely, unplug the power

cord from the wall outlet.

• Unplug the power cord from the wall

outlet to protect your set during heavy
thunderstorms.


Batteries (not included)

Open the battery compartment and insert
eight batteries, type R-14, UM-2 or C-cells,
(preferably Alkaline) with the correct polarity
as indicated by the + a,,nd - s,,ymbols
inside the compartment.

Batteries contains chemical substances, so
they should be disposed of properly.
Incorrect use of batteries can cause electrolyte

leakage and will corrode the compartment
or cause the batteries to burst. Therefore:

Do not mix battery types: e.g. alkaline with
carbon Zinc. Only use batteries of the same
type for the set.

When inserting new batteries, do not try to
mix old batteries with new ones.

Remove the batteries if the set is not be
used for a long time.

BASIC FUNCTION
RADIO
Switching power on/off: Save energy Whether
you are using mains or battery supply, to avoid
unnecessary energy consumption always adjust
the source selector to off.
For FM, pull out the telescopic antenna. Incline
and turn the antenna. Reduce its length if the
signal is too strong (very close to a transmitter).
For AM, the set is provided with a built-in
antenna so the telescopic antenna is not
needed. Direct the antenna by turning the whole
set.

3479.indd 6

3479.indd 6

11.04.2006 16:36:13

11.04.2006 16:36:13

Advertising
This manual is related to the following products: