GrimmSpeed Antenna Delete Plate - Manual (Page 4)

Step 8: Run the power wire and antenna wire to the "A" pillar via the headliner and down under the dash. Run it
over to the radio hole where you will tap the power and plug in the antenna.
Step 9: Add power to the antenna by clipping the antenna power wire onto the accessory wire on the radio.
Step 10: Plug in the antenna to the back of the receiver. To test the antenna’s functionality, turn the car to the
on position and verify the red LED on the amplified antenna lights up when the radio is on. If it does not turn
on recheck your ground and power taps. Reinstall the radio trim, kick panel, map light, and A-pillar trim.
You’re done. Enjoy your new stealth antenna without losing radio reception.