PowerBridge ONE-PRO - Manual (Page 2)

Step 2
In-Wall Installation
A) Begin at the upper PowerOUT location.
Drop or wall-fish audio video cables and NM-type
PowerWire (ROMEX) to the PowerIN location below.
Pull all cables out lower cutout.
Step 3
Plug it in
Plug TV power supply cord in to PowerOUT and connect AV cables to TV.
Follow wall mount manufacture instructions, install TV on wall bracket.
Plug supplied 6’ PowerConnect cord into PowerIN.
Plug other end into existing grounded outlet or surge protector.
CAUTION-Risk of Fire-Only Use Cord Set Provided With This Kit
or equivalent.
Plug in TV Plug in Flat Angle Plug
I) Slide audio video cables through backside through CableBrush.
Allow for enough cable length out to connect to TV and Equipment.
J) Slide both wall plates into wall opening.
Use Flat-Blade screw driver to secure panel to wall.
Careful to not over-tighten.
The PowerBridge In-Wall Extension is now energized.
Existing
Outlet
Surge Protector
B) Strip NM-type PowerWire use Wire Strip Gauge on label.
Remove 1.5” of outer sheath. ½” off Black and White wires.
C) Insert wire through funnel of back-box as shown.
D) Insert small black and white power-light wires with same
color PowerWires as shown on label into back of OUTLET/INLET.
E) Tighten all three screws to 12 in-lbs. securing wires.
F) Bend all three wires toward the cable-brush.
G) Slide back-box onto back, secure with the 4 supplied screws
with supplied hex-tool.
H) Insert tab into funnel, this snaps in place.
G E H
C
F
Wire Connection - Assembly
< Silver
WHITE Wire Screw
TOP
Brass Screw >
BLACK Wire
Green Screw BARE Wire
W
Silver
WHITE Wire Screw >
TOP
< Brass Screw
BLACK Wire
Green Screw BARE Wire
W
G
OUTLET
INLET
Use NM-type building wire.
14/2 size wire only.
Copper wire only
CU
!
D
DO THIS FIRST
!
B
1.5”
1/2” Wire Strip Gauge
NOTE:
Kits supplied with
NM wire are
already pre-stripped