J.P. Instruments EDM 960 Twin Pilots Guide User Manual
Page 20
For Your Safe Flight
Page 15
Linear Gauge Display Section
The linear bar graphs are arranged
in a three by three matrix on the
right half of the display. A typical
layout is depicted here (Note: your
actual configuration may vary).
Typical functions that can be
displayed are:
•
Oil temperature
•
Oil pressure
•
Fuel pressure
•
Bus voltage
•
Amps (charge/discharge shown)
•
OAT
•
Fuel flow
•
Left tank fuel quantity *
•
Right tank fuel quantity *
* The fuel quantity gauges will not be
functional until the fuel calibration process has been completed.
The range of the bar graphs depends on the programming. Range,
redlines and/or limits are typically set to match the original aircrafts
gauge markings. These are locked for Primary installations, however
non-primary gauges can be user modified, using ‘EDM Config’ utility
downloadable from
See ‘Section 9 - First Time Setup
and Customization’.
Note: Amps can operate either as a charge/discharge or load meter,
depending on programming. For charge/discharge, the center of the bar is
zero and the top and bottom are maximum charge and discharge,
respectively.