AEM 30-5130 Analog Wideband UEGO Gauge Gasoline AFR User Manual
AEM For the car
Advertising
Part Number 30-5130
Analog Wideband Air/Fuel Ratio Gauge
Figure 1. Wiring Schematic
AEM Gauge-Type UEGO Controller Parts
1 x 35-5130(B/W) UEGO Gauge Assembly
1 x 30-2001 UEGO Sensor
1 x 35-8535 Install Kit (O2 Bung with 6 Butt Connectors)
1 x 10-5130 Installation Instructions
1 x 35-3411 8-Pin Power Harness
1 x 35-3400 6-Pin Sensor Harness
1 x 35-8529S Silver Bezel
AEM Performance Electronics
2205 126
th
Street Unit A, Hawthorne, CA. 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aempower.com
Instruction Part Number: 10-5130 Rev 02
© 2009 AEM Performance Electronics
Advertising
Table of contents
Document Outline
- INSTALLATION
- RED - Connect BOTH RED wires to a constant 12 volt power source utilizing a 5A fuse.
- BLACK – Connect BOTH BLACK wires to a clean power ground.
- PINK - Connect to a switched 12 volt power source utilizing a 5A fuse.
- GREY - Connect to instrument lighting circuit supply voltage.
- *WHITE - Connect to Lambda + Input.
- *BROWN - Connect to Lambda – input. (Must be connected if Lambda + is used)
- Changing the Bezel
- The Analog Wideband UEGO Gauge has 7 different backlight colors available to the end user, which closely match some of the more common factory dash panels: white, blue, green, red, orange, light blue, and aqua. To change the backlight color, rotate the backlighting switch using a small precision style screwdriver. The backlight switch is accessed through the small hole in the back of the gauge.
- Status Lights
- Analog Output