Snorkel SR SERIES - Manual (Page 63)

12. OPTIONS
12 - 1 P/N 569300
This chapter lists and explains all the options
available for an SR.
T
OPERATOR HORN
The operator HORN button is on the right side
of the platform-control box. For the HORN to
work the BATTERY switch must be ON and the
following switches, on the ground control panel,
must be set as indicated:
SELECTOR SWITCH .......platform
EMERGENCY STOP........out for run
KEY SWITCH ...................on
The operator HORN is used primarily to get the
attention of people on the ground when you are
working aloft.
T
OUTRIGGERS
The outrigger controls are on the upper left side
of the platform-control box.
The outriggers are used to level the SR (for
complete outrigger operating procedures see
the “OPERATION” chapter).
NOTE: The SR must be on a firm surface
capable of withstanding all load forces
imposed by the aerial platform in all
operation conditions before the outriggers
are used.
T
GFCI OUTLET
The GFCI (ground fault circuit interrupt) is
located under the platform-control box. To use
the outlet the SR must have the AC
GENERATOR option or you must plug the
power cord, at the base-control panel, into a
source of power. Set the AC OUTLET SWITCH
(on the platform-control box) to on (-).
The GFCI will protect against short circuits to
ground. When there is a short to ground the
GFCI will shut off power to the outlet.
To reset the outlet:
Unplug the equipment being used.
Press the reset button on the GFCI outlet.
This should restore power to the outlet. If it
does not, set the AC OUTLET SWITCH to off
(O) and refer the problem to a trained service
technician.
T
BIG PAW TIRES
Because Big Paw tires are wider than standard
tires, Big Paw tires decrease the pressure the
SR exerts on the ground and give more traction
than standard tires. Therefore, Big Paw
12. OPTIONS