AMMCO 9233GP Double Taper Cone Adapter Sets - Manual (Page 2)

Care of Adapters
The adapters are so precisely manufactured that a lathe
arbor in poor condition will affect their accuracy. Replace
an arbor that is warped or badly nicked and dented on the
spindle mating surfaces.
Handle each adapter as if it were fragile, even though it
is made of premium grade alloy steel and hardened.
Wipe clean after each use. A tiny chip or smear of dirt can
affect the mounting accuracy. Check all adapters for
dents, scratches or nicks that may have been caused by
one hardened adapter striking another accidently.
Correct these imperfections with a fine stone.
Store adapters carefully, don’t dump them in a carton to
collect nicks and dirt. Remove and clean all adapters each
time you machine a drum or rotor, especially the inboard
adapter. As you remove the drum or rotor, the inboard
adapter can move away from the face of the arbor letting
chips fall between the two surfaces.
Finally, don’t use the adapters for anything but mount-
ing rotors and drums. They are NOT tail pipe expanders
or arbor press adapters.
Truck Set No. 909233GP
For 1-inch Arbors
NO. 909195, 1 each.
Range: 2.828" to 3.185"
(71.8 mm to 80.9 mm)
NO. 909196, 1 each.
Range: 3.203" to 3.560"
(81.4 mm to 90.4 mm)