Gamber-Johnson 7110-0161 - Manual (Page 2)

Step 2. Assemble the two extension plates, from the 7110-0161 Add On Bracket Set, to the inside of the
vertical side legs of the StackMaster, StackAbout, FloorMaster, or FlexMaster products as shown in
Figure 2. Temporarily use one carriage bolt, washer, and nut, that came with the add on bracket set, for
each extension plate. Adjust the extension plates to the needed height before tightening.
Extension plates
Figure 2
1/4-20 x 3/4 carriage bolts, washers, and nuts.
Step 3. Reinstall the equipment brackets as shown in Figure 3 using the hardware removed in Step1 from
the Stackmaster, StackAbout, FloorMaster, or FlexMaster products and the 7110-0161 Add On Bracket
Set. If the carriage bolts holding the vertical extension plates are in the way, move these bolts up or down
as needed and retighten. (Each extension will now be supported by a carriage bolt and at least one other
bolt.)
Figure 3
Use 1/4-20 x .38" long hex head
screws and washers removed in
Step 1 to assemble 7110-0161
brackets.
Reattach brackets removed in
Step 1 with 1/4-20 x .62" long
hex head screws and washers
supplied with 7110-0161
2/2