Heidolph SilentCrusher S - Manual (Page 26)

26
E
SERVICE AND OPERATION
1 Start-up
Caution: Never operate the SilentCrusher S with dispersion tool when the
dispersion tool is not immersed in fluid. Operating the device dry will destroy the
PTFE bearing (Q, see Chapter 6.2-Cleaning and Maintenance) and the rotor (O,
see Chapter 6.2-Cleaning and Maintenance).
Connect the power connection cable (D) to the power supply. The green control light (H)
on the power supply (unit) (B) will light. The device is now ready to operate.
Due to its low power consumption, the device does not have a mains switch. If
the device is connected to the mains voltage (standby), the device consumes
only 3 Watts.
To disconnect the device from the power supply system, unplug the mains plug.