INCRA T-Rule - Manual

Easy and Accurate
To mark with a 0.5mm Mechanical Pencil: Just hold the pencil vertically and draw a short line in one of the slots,
or twist the pencil in a hole to mark a dot.
To mark with a Wooden Pencil:
First, sharpen the pencil, then twist the lead once or twice in any one of the holes to
give it an ultra fine point ready for marking.
To mark with a Metal Scribe or Center Punch:
Any scribe or center punch sharp enough to fit through the holes can
be used. Use finger pressure ONLY to mark a precisely located “dimple” in soft materials such as wood, paper, plastic,
brass or aluminum. DO NOT damage your precision rule by pounding the point through the hole with a hammer.
6” Precision T-Rule
Put YOUR Mark on Precision
Any rule can
just measure,
but only
INCRA
guarantees
YOUR mark
of precision
on everything
you do!
7
51922 50603
2
Precision T-Rule
6" Precision T-Rule
Fig B.eps
6" Precision T-Rule
Fig C.eps
6" Precision T-Rule
Fig D.eps
0
1
1
2 INCRA RULES
INCR A R
ULES
STAINLESS STEEL 32NDS
16THS
64THS
32NDS
32NDS
16THS
64THS
64THS
+ 0/64
+ 1/64
+ 2/64
+ 3/64
MADE IN US A
MADE IN US A
STAIN LESS STEE L
3
4
5
6
2
3
4
5
6
AEN ENDIN
1
0
3
4
5
6
2
E
Indexing Lip
Fig F.eps
Indexing Lip
Your INCRA T-Rule is a precision measuring and marking instrument for use in many applications.
Marking relative to the
end or edge of your
workpiece:
Put the T-Bar against
the end or edge of your
workpiece, then make your
mark in the hole or slot at
the desired measurement.
Drawing a line parallel
to the edge of your
workpiece:
You can draw a line by
sliding the T-Bar along the
edge of your workpiece
while holding the pencil
vertically in one of the
holes at the desired
measurement.
Drawing a line
perpendicular to the
edge of your workpiece:
With the T-Bar against your
workpiece at the desired
location, draw a line along
the T-Rule’s edge.
Making vertical
measurements:
Position the T-Rule at one
end of the T-Bar as shown.
The scale at the end of the
T-Rule can be used for
vertical measurements.
Adjusting the T-Bar:
Your INCRA T-Rule comes
fully assembled. If you ever
loosen the two thumb
screws, be sure to place
the end of the T-Rule
firmly against the indexing
lip on the T-Bar before
retightening to insure
perfect accuracy.
INCRA has re-invented the steel rule by putting
micro-fine marking holes at every scale position
to locate a sharp pencil point or scribe exactly on
target! Now, instead of squinting as you try to
line up your pencil on that blur of lines along the
edge of your old steel rule, you can instantly put
your mark precisely where you want it with zero
uncertainty and no eye strain.
When accuracy counts … INCRA RULES!
INCRA RULES are available in many other popular styles and lengths.
Manufactured by:
Taylor Design Group, Inc.
P.O. Box 810262
Dallas, Texas 75381 USA
www.incra.com
INCRA is a Registered Trademark
of Taylor Design Group, Inc.
© 2013 Taylor Design Group, Inc.