Arrow keys, Program key, Arrow keys -4 – INFICON MDC-360C Thin Film Deposition Controller User Manual
Page 30: Program key -4, Figure 2-3 programming section -4, Figure 2-4 arrow keys -4
MDC-360C DEPOSITION CONTROLLER
FRONT PANEL DISPLAYS AND CONTROLS
2-4
Figure 2-3 Programming Section
2.3.9 ARROW KEYS
The arrow keys are used to navigate through the programming and setup menu
structure. These keys will auto-repeat if they are held down for more than half a
second.
2.3.10 PROGRAM KEY
Pressing the programming key will bring up the last viewed programming screen.
If a programming screen is already shown, nothing will happen. This key is also
used in conjunction with the Up and Down Arrow keys to adjust the contrast of
the Parameter/Status display. If the screen background is white then press and
hold the Program and the down arrow keys until the text is easy to read. If the
screen background is blue and the text cannot be seen then press and hold the
Program and the up arrow keys.
Figure 2-4 Arrow Keys