INFICON Cube CDGsci (REST Services) - Manual (Page 5)

tira88e1-a (2014-03) CDGsci.cp
5
2 Interface Connection
For operating the temperature controlled CDGsci gauge via Ethernet, one interface
cable conforming to the Ethernet standard is required.
If no such cable is available, make one according to the following indications.
Ethernet Cable or Crossover Cable (CAT5e quality) with FCC68 connector.

Pin assignment:
8 1
RJ45, 8-pin,
male, soldering side
Pin Signal Description
1 TD+ Transmission Data +
2 TD- Transmission Data -
3 RD+ Receive Data +
4 nu not used
5 nu not used
6 RD- Receive Data -
7 nu not used
8 nu not used
Pin assignment of the D-Sub 15-pin sensor connector according to the
respective operating manual (
→  [1]).

Plug the Ethernet (and sensor) cable connector into the gauge as shown.
Ethernet cable
RJ45
Ethernet interface
Cable type
Procedure