IPitomy IP1000 Upgrade Guide - Manual (Page 4)

Page 4 of 8
Copyright 2009 © IPitomy Communications, LLC
[Note] If the computer you are using to upgrade is connected to the PBX through the
WAN port, you will need to ensure that Remote Upgrade is enabled under Networking-
>Administration->Administration
2. Click on Browse and find the current firmware file ip1000-<build#>.bin
3. Click on Start to Upgrade to begin the upgrade process
4. After the file is loaded, the PBX will reboot. When the reboot finished, unplug the power
for 15sec then reconnect the power
Initializing Storage
1. Log into the PBX and navigate to PBX Setup=>Services