Juki HZL-35Z - Manual (Page 44)

44
ADJUSTING TOP THREAD TENSION
STRAIGHT STITCHING
The good looking appearance of your stitching is largely
determined by the balanced tension of both top and
bobbin threads. The tension is well balanced when these
two threads 'lock' in the middle of layers of fabric you are
sewing.
Set the thread tension dial at "5" for ordinary sewing.
If, when you start to sew, you find that the stitching is
irregular, you will need to adjust the thread tension dial.
Make any adjustments with presser foot 'down'.
CHANGING PRESSER FEET
Be sure needle is in the up position. Raise presser foot
lever.
1. Raise presser foot release lever to remove the foot.
2. Place the desired foot on the needle plate aligning
needle holes.
3. Lower the presser foot lever so that the foot holder
snaps on the foot.
Always disconnect the machine from power
supply by removing the plug from the
socket-outlet.
CAUTION
BOBBIN TENSION
The bobbin tension has been correctly set at the factory,
so you do not need to adjust it.
Under side
Reverso
Top side
Cara
Well balanced
Bien equilibrada
1
3
2
Palanca de
desprendimiento prensatelas
Presser foot lever
Palanca pie prensatelas
Presser foot release lever
Puntada superior
demasiado apretada
Top stitch too tight
Puntada superior
demasiado floja
Top stitch too loose