Paxton Net2 PaxLock - Manual (Page 7)

Page 7
PaxLock reset
The PaxLock holds address information for the bridge that it is bound to. This will cause
problems if the unit is to be used on another system.
The unit requires a hardware reset to clear its bridge information. This is achieved as follows:
1. Remove the inside handle from the door by loosening the securing grub screw.
2. Remove the cover by holding the bottom edge and pulling it towards you. The cover will lift
off at the top when the bottom edge is clear of the housing.
3. Locate the black reset button at the top of the unit.
4. Hold the button down and wake up the unit by pressing the front push button.
The unit will give a beep when the reset has started. You can now release the reset button.
5. The Red and Green LED's will both flash until the process has finished.
6. Refit the cover and handle.
7. You can now enrol the unit.
10,000
250
64
3584
2,405 Ghz
10
200
20 m
0 °C + 55 °C
IPX4
20 mm 5 mm
40 mm 324 mm 35 mm
160 mm 324 mm 100 mm
35 mm 60 mm
35 degrees
Operating temperature - Battery limits
Environment
Dimensions
Features
External use
Min
Width Height
Max
Depth
Min Max
Access levels
Time zones
Door open time
ACU's per Net2Air bridge - Recommended
Events stored in ACU with no server connection
Number of tokens
Specifications
No
Net2Air bridge per system
Net2Air wireless range
The declaration of conformity is available on request. Contact details are provided at: http://paxton.info/596
Low
Reader/Keypad module (required space on door)
Total outside dimensions (includes handle clearance)
Battery type
Typical battery life
Vandal resistance
Read Range Keyfob Token
This product is not suitable for retail sale. All warranties are invalid if this product is not installed by a competent person.
2 years or 30,000 ops 3 years or 60,000 ops Max = Low power mode
1 sec 60 secs
4 x AA Alkaline
The Net2 PaxLock is EN1634-1:2008 FD30 and FD60 Fire resistant.
Door thickness supported
Communication
Carrier frequency
Handle rotation
Min Max
Min Max