Spaulding Lighting Laredo LMC18LED & LMC30LED - Manual

WARNING! LUMINAIRES require high current and voltage.
WARNING! Fixtures must be grounded and installed in accordance with the National Electrical Code and all local codes. Failure to
do so may increase the RISK OF PERSONAL INJURY, PROPERTY DAMAGE, FIRE AND DEATH. Install and use so product does not
cause a hazard and use only in environments for which the product is specifically marked.
WARNING! This product contains chemicals known to the State of California to cause cancer, birth defects, and/or other reproductive
harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
CAUTION! Follow ALL luminaire manufacturer's recommendations, product markings, instructions, restrictions and warnings
regarding lumninaire operation, burning position, cycling and lamp replacement. Luminaire label shows electrical and environmental
requirements.
All electrical work must be done by a qualified electrician.
Turn off electric power to all affected circuits and allow to cool before servicing.
A regularly scheduled maintenance program should be established to retain optimum light output and reduce heat retention. Dusting
with a soft, clean, dry cloth is normally sufficient for the optical assembly. Any accumulation of dust or dirt should be removed regularly.
Carefully read these instructions before installing product. If you do not understand these instructions, before starting any work, contact
your Hubbell Lighting distributor or [email protected] or (864) 678-1000
Give instructions to facility owner/manager for future reference.
LAREDO LMC LED INSTALLATION INSTRUCTIONS (PG 1/2)
SAVE THESE INSTRUCTIONS
701 Millennium Boulevard Greenville, SC 29607 (864) 678-1000 www.hubbelloutdoor.com
STEP I MOUNTING PREPARATION
CAUTION: FIXTURE WEIGHS ABOUT 15 POUNDS
• Using mounting bracket (A) as a template, align slots in
bracket with mounting holes in junction box (B) on the
wall. Mark hole locations (4) 4.5” square. (See Fig.1)
• Drill wall for the hardware appropriate for the type wall.
Use 1/4 diameter bolt (supplied by others) and attach
bracket to wall.
• Pull the supply wires (C) from junction box (B).
• Apply caulking sealant (supplied by others) around the
top and two sides of the bracket where it meets the wall.
4.500
4.500
B
A
C
93029166 Rev C - Page 1 of 2
CAULKING
FIG. 1
NOTE: DO NOT OPEN THIS PRODUCT UNLESS INSTRUCTED BY STEPS INCLUDED IN
THESE INSTRUCTIONS OR BY HUBBELL LIGHTING TECHNICAL SUPPORT PERSONNEL.
FIXTURE HAS BEEN DESIGNED WITH EASY TO INSTALL MOUNTING BRACKETS.
TOOLS REQUIRED: FLAT BLADE SCREWDRIVER OR 5/16” NUT DRIVER, DRILL, ANY
ADDITIONAL TOOLS NEEDED FOR APPROPRIATE WALL FASTENERS
PARTS REQUIRED: (SUPPLIED BY OTHERS) SILICONE CAULK, 1/4” WALL ANCHORS
AND FASTENERS APPROPRIATE FOR WALL CONSTRUCTION TYPE
CAUTION: SHOCK HAZARD! IF YOUR PRODUCT IS EQUIPPED WITH A –BOC OPTION, DO
NOT CONNECT BATTERY BACKUP RED AND WHITE WIRES UNTIL INSTRUCTED TO IN
THESE INSTRUCTIONS (SEE STEP III)