Vicor PFC MicroS Power Factor Corrected AC-DC Switcher - Manual (Page 20)

Pg. 20 Vicor 800-735-6200 Westcor Division 408-522-5280 Applications Engineering 800-927-9474 03-000049 rev A
PFC MicroS Design Guide
Figure 3. Cable Drawing
P 1
24.0" +/- 1.0"
Po w e r
T 1
- V 1
T 2
- V 2
R e d , 2 2 AW G
Yellow, 22 AWG
B r ow n , 2 2 AW G
W h i t e, 2 2 AW G
Black, 22 AWG
1 2
3 4
5 6
1.74"
(44.2mm)
0.12"
(3.0mm)
1.500"
(38.1mm)
0.12"
(3.0mm)
0.900"
(22.9mm)
1.14"
(29.0mm)
0.13" (3.3mm) Dia Non
Plated thr u hole 4
places
M o l ex C T 4 3 0 4 5 F s u r fa c e m o u n t a bl e
connector. .390" height above board.
P i n D e s c r i p t i o n
1 P o w e r
2
T 1
3 - V 1
4
T 2
5 - V 2
6
N o C o n n e c t i o n
J1 Pinout
Figure 2. Mechanical Drawing
CURRENT SHARE BOARD -Continued
Specifications:
1. Power: 2-50Vdc at 5mA maximum.
2. Accuracy: +/- 1mV between -Vout connections.
3. Output current when not trimming up: +/- 1uA (VI-200/J00), +/-5uA (Maxi/Mini/Micro).
4. Use 4 non-plated through holes with standoffs for mounting.
5. CSB01 MUST be used for current sharing VI-200/VI-J00 converters.
6. CSB02 MUST be used for current sharing Maxi/Mini/Micro converters.
***PLEASE NOTE, THE CSB IS NOT INTENDED FOR HOTSWAP APPLICATIONS***
Contact your Regional Applications Engineer at 1-800-927-9474 for additional information.