Vigo VG06062 User Manual
Page 7
STUD
FIG.2
FIG.3
A
B
9
11
THIS EDGE LOOKS
OUTSIDE OF THE SHOWER
THIS EDGE LOOKS
INSIDE OF THE SHOWER
18
FIG.2A
1.
Remove the aluminum cover from the front piece of the bottom rail by sliding it out.
2.
Remove top of the corner joint. Slide the bottom corner joint (2 pieces) (#11) onto the bottom rail
(3 pieces) (#9). [SEE FIG.3]
3.
Align the bottom rail and corner joint to the desired position on the shower base. Make sure the A
and B distances are correct (see page 3 for A and B distances). Prior to drilling, dry fit everything
making sure that everything is straight, level and plum. Pre-drill for sinkers and
tap sinkers. Cut excess sinker off with hacksaw or sharp blade. Dip screws in silicone. [SEE
FIG.2A] Screw corner joints and rails down. Silicone tops of screws.
4.
Seal the bottom rail with clear silicone caulk and center its sides to the base.
5.
Clip the aluminum cover to the front piece of the bottom rail making sure the lower side faces the
inside of the shower. [SEE FIG.3A]
6.
Silicone the underneath portion of the corner joint caps and put them on the corner joints. [SEE
FIG.3A]
7
MODEL VG06062
TOP REMOVES TO
INSTALL 3/4" SCREW
OUTSIDE
INSIDE
ALUMINUM COVER
FIG.3A
INSIDE
OUTSIDE
CORNER JOINT CAP