Vortex Optics VIPER HS LR 2.5-10X32 RIFLESCOPE — First Focal Plane - Manual (Page 7)

HS LR
RIFLESCOPE
13 12
Indexing Adjustment Dials with Zero Reset
Viper HS LR riflescopes feature windage and elevation dials that allow
you to re-index the zero indicator after sight-in without disturbing
your settings. This allows you to quickly return to your original zero
if temporary corrections are used in the field. Index the windage and
elevation dials in this way:
1. Remove the outer cap and pull the adjustment dial outward
against the spring tension until it stops.
2. With the dial pulled fully outwards, rotate the dial to reposition
the zero mark on the index line.
3. Release the dial, allowing it to return to the normal inward
position.
Remove the outer
cap and expose
the turret dial.
Grasp turret dial, pull
upward and rotate
until the etched zero
mark (arrow) aligns
with the indicator line
on scope body.
M
AINTENANCE
The fully waterproof and fogproof Viper HS LR riflescope requires very
little routine maintenance other than periodically cleaning the exterior
lenses. The exterior of the scope may be cleaned by wiping with a soft,
dry cloth.
Cleaning
• Be sure to blow away any dust or grit on the lenses prior to wiping the
surfaces.
• Using your breath, or a very small amount of water or pure alcohol, can
help remove stubborn things like dried water spots.
All components of Viper HS LR riflescopes are permanently lubricated,
so no additional lubricant should be applied.
Lubrication
When cleaning the lenses, be sure to use products, such as the Vortex
Fog Free cleaning products or LensPen, that are specifically designed for
use on coated optical lenses.
Note: Other than removing the turret caps, do not attempt to disassemble
any components of the riflescope. Disassembling of riflescope may void
warranty.
If possible, avoid exposing your Vortex riflescope to direct sunlight or any
very hot location for long periods of time.
Storage