Rockwell Automation 1768-L45S Compact GuardLogix Controllers - Manual (Page 63)

Rockwell Automation Publication 1768-UM002C-EN-P - April 2012 63
Add, Configure, Monitor, and Replace CIP Safety I/O Chapter 5
A CIP Safety I/O device address follows this format:
Modulename:Type.Member
Monitor Safety I/O Module
Status You can monitor safety I/O module status via explicit messaging or via the status
indicators on the I/O modules.
These publications provide information on I/O module troubleshooting:
• Guard I/O EtherNet/IP Modules User Manual, publication
1791ES-UM001
• POINT Guard I/O Safety Modules Installation and User Manual,
publication
1734-UM013
Table 13 - CIP Safety I/O Module Address Format
Where Is
Modulename The name of the CIP Safety I/O module
Type Type of data
Input: I
Output: O
Member Specific data from the I/O module
Input-only Module: Modulename:I.RunMode
Modulename:I.ConnectionFaulted
Modulename:I.Input Members
Output-only Module: Modulename:I.RunMode
Modulename:I.ConnectionFaulted
Modulename:O.Output Members
Combination I/O: Modulename:I.RunMode
Modulename:I.ConnectionFaulted
Modulename:I.Input Members
Modulename:O.Output Members
Table 14 - Additional Resources
Resource Description
Chapter 8 , Monitor Status and Handle Faults Contains information on monitoring safety tag data
Logix5000 Controllers I/O and Tag Data Programming
Manual, publication
1756-PM004
Provides information on addressing standard I/O modules