Rockwell Automation 2071-APx Kinetix 3 Drive Systems Design Guide - Manual (Page 5)

Rockwell Automation Publication GMC-RM005B-EN-P - September 2013 5
Kinetix 3 Drive Systems
Kinetix 3 I/O Wiring Options
(1) Refer to Kinetix 3 I/O Breakout Board Installation Instructions, publication 2071-IN002 , for pinout information. No I/O wiring is needed with serial communication control.
(2) Refer to Kinetix 3 Component Servo Drives User Manual, publication 2071-UM001 , for pinout information. No I/O wiring is needed with serial communication control.
Kinetix 3 Configuration (ASCII control)
Kinetix 3 Configuration (Modbus control)
(1) Could also be MicroLogix 1100 controller (catalog number 1763-L16xxx).
Kinetix 3 Configuration (2080-SERIALISOL communication module)
2071-Axx
Kinetix 3 Drive
2071-TBIO
(1)
Limited I/O Breakout Board
(provides access to 24 of the most commonly used terminals)
2090-DAIO-D50xx
(2)
Full Breakout (50-pin, flying-lead) I/O Cable
(provides access to all 50 terminals)
ESC
OK
2071-Axx
Kinetix 3 Drive
1766-L32xxx
MicroLogix 1400
Controller
2090-CCMPCDS-23AAxx
Programming Cable
(programming only)
Ultraware Software
(version 1.80 or later)
ASCII (RS-232C)
Communication Port
ESC
OK
F1 1 F2 2 F3 3 F4 4 F5 5
F6 6 F7 7 F8 8 F9 9 F10 0
2071-Axx
Kinetix 3 Drive
2090-CCMCNDS-48AAxx
Controller Cable
RSLogix 500 Software
1766-L32xxx
MicroLogix 1400 Controller
(1)
2071-Axx
Kinetix 3 Drives
2090-CCMDSDS-48AAxx
Drive-to-Drive Cables
2090-CCMPCDS-23AAxx
Programming Cable (programming only)
Non-isolated
Serial Communication Port
PanelView Component
Display Terminal
1585J-M8CBJM-x Ethernet Cable
2071-Axx
Kinetix 3 Drive
Remove cable connector and
wire flying-leads to serial
communication module.
2080-SERIALISOL
Isolated Serial Communication Module
2090-CCMPCDS-23AAxx
Programming Cable (programming only)
2090-CCMCNDS-48AAxx
Controller Cable
Connected Components
Workshop Software
2080-L30xxxxx
Micro830™ Programmable Controller (24-point is shown)