Brother NC-4100H - Manual (Page 103)

CHAPTER 9 LAT NETWORK CONFIGURATION
9-4
2. Use the VMS editor to create a text file with the necessary configuration
commands (alternatively, you may edit the file LAT$SYSTARTUP.COM
for VMS 5.5-x and later systems or LTLOAD.COM for earlier VMS
systems). For instance, the following sample command file creates a queue
named XJ on LAT port 33 for a print server with a default node name of
BRN_310107 using the LATSYM processor and the default VMS form:
$MCR LATCP
CREATE PORT LTA33:/APPLICATION
SET PORT LTA33:/NODE=BRN_310107/PORT=P1
SHOW PORT LTA33:
EXIT
$SET TERM LTA33:/PASTHRU/TAB/NOBROADCAST-
/PERM
$SET DEVICE/SPOOL LTA33:
$INIT/QUEUE/START/ON=LTA33:/PROC=LATSYM XJ
Substitute your actual node name, port name (P1), LAT port and queue name for the
ones in the example. If you are using a service name, specify
/SERVICE= servicename instead of /PORT=P1.
Use the default names unless you have specifically changed the names.
Be sure to specify PROC=LATSYM or the queue will not service requests from
multiple host computers.