Dynalite Power Pack - Manual (Page 8)

M500xl
Power Pack
AC On / Off Power Switch - Turns power pack
on and off.
Modeling Light Switch - Three-position
modeling light control; full on, off, or direct
tracking. Flash head fans always run at full
speed regardless of switch position.
One stop Variator Conrol - Click stops allow
you to fine-tune your basic power settings in
1/3 stop increments. Used in combinations,
the power control switches and Variator pro-
vide a total of 15 different power settings with
a single flash head.
Power Control Switches - Three position full/
half/quarter power switches provide power
settings from 62 to 250 watt/seconds per
channel. (These can be trimmed using the
Variator or combined using the Ratio output
switch.)
Flash Head Outlets - The pack can accept up to three heads. Each outlet is completely arc protected. You can plug and
unplug flash head cables without shutting down the power pack.
AC Power Cord Socket and Circuit Breaker - Offers easily reset-able protection.
Ratio/Combined Output Switch - An indicator light tells you whether your power is routed symmetrically or asym-
metrically between the “A” and “B” flash head outlet banks.
Audible Ready Indicator Switch - Audible beep for aural confirmation.
Sync Input Socket - Outlet for plugging in sync cord or optional radio slave.
Ready Light/Test Switch - When lit the pack is fully charged. This button can also be used to manually trigger the pack.
Built-in WEIN slave-eye with on/off switch - Can be triggered by any flash and will also respond to most infrared trig-
gers.
4.
5.
6.
3.
2.
1.
11.
10.
9.
8.
7.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.