Metrohm 838 Advanced Sample Processor Manual User Manual
838 advanced sample processor
Advertising
Table of contents
Document Outline
- EN.pdf
- Title
- Table of Contents
- List of Illustrations
- 1 Introduction
- 2 Operation
- 2.1 Operating principles
- 2.2 Configuration
- 2.3 Composition of a method
- 2.4 Commands
- 2.4.1 Sample Processor commands
- SAMPLE
- Set current sample position
- MOVE
- Position beaker / Swing robotic arm
- LIFT
- Lift positioning
- 2.4.2 Switching components
- PERISTALT
- Pump control
- PUMP
- Switching the pump connectors
- STIR
- Stirrer control
- 2.4.3 Dosing drive control
- DOS
- Dosing device control
- 2.4.4 Communication commands
- SCAN
- Scans the Remote interface
- Scanning the RS232 interface
- CTL
- Setting the Remote lines
- Data transmission via serial interface
- 2.4.5 Auxiliary commands
- WAIT
- Waiting time
- RACK
- Initialize rack
- 2.5 Managing methods
- 2.6 Run control
- 2.7 Manual operation
- 2.7.1 Turning the sample rack / Positioning the samples
- Position vessel / Turn rack
- 2.7.2 Moving the lift
- Position the lift
- 2.7.3 Setting the sample position
- Define current sample position
- 2.7.4 Pump control
- Switch peristaltic pump on/ off
- 2.7.5 Switching the stirrers
- Stirrer control
- 2.7.6 Dosing device control
- Dosing functions
- 2.7.7 Display interface signals
- Display remote interface signals
- Display RS232 interface signals
- 2.7.8 Interface control
- Setting the remote lines
- Data communication via RS232 interface
- 2.7.9 External pump control
- Switching the pump connectors
- 2.7.10 Switching the injection valve
- Switching the injection valve
- 2.7.11 Rack initialization
- Initialize the sample rack
- 2.8 Dosing and liquid handling
- 3 Appendix
- 4 Index