SCHOEPS VMS 5 U - Manual (Page 2)

2
Control layouts:
Front:
<1> Signal level indicators
<2> Preamp gain control
<3> Left/Right balance control
<4> Switch for low-cut filter
<5> Channel assignment switch (for
M/S)
<6> Stereo width control (for M/S)
<7> Main output selector
<8> Headphone jack
<9> Headphone output selector
<10> Headphone level control
<11> Phantom power switch
<12> Battery level meter
<13> External power indicator (yellow);
low-battery warning (red)
<14> On/Off switch
Rear, as seen from above*:
<15> Input for SCHOEPS active Y-cable
<16> Balanced XLR microphone inputs
<17> Balanced XLR line outputs
<18> Input for external power supply
<19> Input selector switch
* The connectors and labels on the rear
of the VMS 5 U are “upside-down”
with respect to the front of the unit.
This simplifies its use, since the unit
does not need to be turned around
sideways to read the labels.
Table of contents
1. Inserting batteries . . . . . . . .4
2. Battery level meter . . . . . . . .5
3. Automatic shutoff . . . . . . . .6
4. External powering . . . . . . . .6
5. Connecting microphones . . .8
6. Setting the preamp gain . . .9
7. Balance setting . . . . . . . . . .9
8. Signal level indicators . . . . .9
9. Low-cut filter . . . . . . . . . . . .9
10. Connecting the outputs . . .10
11. Connecting headphones . .11
12. M/S recording/WIDTH . . . .11
13. M/S dematrixing . . . . . . . .15
14. M/S side inversion switch .15
15 Technical specifications . . . .16
16. Block diagram . . . . . . . . . .18
17. Important information . . . .20
18. Warranty . . . . . . . . . . . . . .21