Casio fx-115ES - Manual (Page 67)

E-65
• The values are based on ISO Standards (1992) and CODATA
Recommended Values (1998). For details, see Appendix
<#114>.
Appendix <#115> and <#116>
Perform all of these examples in the COMP Mode (N1).
Metric Conversion
The calculator’s built-in metric conversion commands make it simple
to convert values from one unit to another. You can use the metric
conversion commands in any calculation mode except for BASE-N
and TABLE.
To recall a metric conversion command, press 18(CONV). This
displays the metric conversion command menu. Input the two-digit
number that corresponds to the metric conversion you want to recall.
See Appendix <#117> for a list of all of the metric conversion
commands and conversion formulas.
• Conversion formula data is based on the “NIST Special Publication
811 (1995)”.
* “cal” uses the NIST value at 15
°C.
Appendix <#118> to <#120>
Perform all of these examples in the COMP Mode (N1).
Technical Information
k Calculation Priority Sequence
The calculator performs calculations according to a calculation priority sequence.
• Basically, calculations are performed from left to right.
• Expressions within parentheses have the highest priority.
• The following shows the priority sequence for each individual command.
1. Function with parentheses:
Pol(, Rec(
∫
(, d / dx (, Σ(
P(, Q(, R(
sin(, cos(, tan(, sin–1(, cos–1(, tan–1(, sinh(, cosh(, tanh(, sinh–1(, cosh–1(,
tanh–1(
log(, ln(,
e ^(, 10^(, '(, 3'(
arg(, Abs(, Conjg(
Not(, Neg(
det(, Trn(
Rnd(
2. Functions preceded by values, powers, power roots:
x 2, x 3, x –1, x !, ° ’ ”, °, r, g, ^(, x
'(
Normalized variate: ' t
Percent: %