Valco Baby Zee Two - Manual (Page 2)

ASSEmbly
FIGURE A - CONTENTS
1. Remove the stroller from the
carton and dispose of all packaging
thoughtfully. Check contents.
FIGURE B - OPENING
2. Release frame lock on side of stroller
frame.
3. Lift the stroller handle upward over
180° until it locks into a straight line.
4. With one hand holding the lower legs
down, lift the handle vertically until
the lower chassis locks into position.
(You should hear an audible ‘click’).
IMPORTANT WARNING:
ALWAYS TEST THAT ALL LATCHES ARE SECURELY
ENGAGED BEFORE USE.
FIGURE C - INSERTING REAR AXLE
5. Align the plastic housings of the rear
brake section with the open tubes of
the rear of the stroller chassis.
IMPORTANT: BE SURE THAT THE BRAKE LEVER IS
UPRIGHT
6. Insert the housings over the open
tubes until the brake section locks
securely into place.
IMPORTANT WARNING:
TEST THAT THE BRAKE SECTION IS SECURELY
ENGAGED ONTO THE STROLLER FRAME BY PULLING
ON IT FIRMLY.
A
B
C
▲ !
▲ !
▲ !
▲ !
3
4
2
2 x HOODS
BASKET
2 x FRONT WHEELS 2 x REAR WHEELS
BRAKE
2 x AXELS
BUMPER BAR
SEAT SEAT