VICI D-4-I-VA38-R - Manual (Page 14)

12
Installation
Detector Electrical Connections
CAUTION: Do not use a wrench to tighten the SMC
connectors on the bias and electrometer cables.
Connections should be finger tight only.
1. Referring to Figure 9 as necessary, connect the BIAS cable to the top
electrode and the electrometer cable (ELECT) to the bottom electrode.
2. Connect the high-voltage cable from the detector to the pulse supply.
3. Connect the heater cable from the detector to the power board.
(Figure 8)
VARIAN
HEATER CABLE
PULSER
MODULE
ELECTROMETER CABLE
P/N: I-23230
BIAS CABLE
P/N: I-23404-1
VARIAN
ELECTROMETER
BOARD
VARIAN
POWER
BOARD
PUSH BUTTON
SWITCH
PULSER CABLE
P/N: I-236 2 8
Figure 9: Schematic of electrical connections