OSRAM SYLVANIA BoxLED Plus DS BX12BA-W4F - Manual (Page 7)

3.0 ELECTRICAL INSTRUCTIONS
3.0 Use wire nuts or connectors to connect the white and red (+) input wire of the
modules to the red (+) output wires of the 24V power supply. Connect the black and
white (-) input wire of the modules to the blue (-) output wire of the 24V power supply
(see Figure 11).
3.1 Cap off any unused connection wires when finished.
3.2 Make sure AC line is OFF before beginning power supply installation. Secure power
supply to clean metal surface using screws (see Figure 12).
Figure 11 Figure 12
3.3 OPTIONAL AC DISCONNECT SWITCH INSTALLATION: Connect disconnect switch in
line with VAC line (black wire) (see Figure 13).
Figure 13 Figure 14
3.4 Finish power supply AC connection by connecting black VAC line to black input cord of power
supply, and white neutral to white input cord of power supply. Connect green ground wire from line to
the same metal surface the power supply is mounted on (see Figure 14).
VAC into Disconnect Switch
Optional
Disconnect
Switch
VAC out from
Disconnect Switch