Quoizel TF1784VB Tiffany - Manual (Page 3)

12 1
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
FIGURE #2
OPTION ‘B’
FIGURE #3
TUCK WASHER
12
1
12 O’CLOCK
1 O’CLOCK
CENTER HOLE
FROM FIXTURE
SAFETY CABLE
TUCK WASHER
1 O’CLOCK HOLE
12 O’CLOCK HOLE
CENTER
HOLE
5) For OPTION ‘B’: Pull all of the excess cable through all of the holes in the TUCK WASHER until the TUCK
WASHER is very close to the COUPLING. Remove as much slack as possible. About 1” or less is acceptable.
(See FIGURE #2)
6) Coil and stow the excess cable near the TUCK WASHER. For excessive cable, the cable can be cut down to
a minimum of 12” from the washer. At the COUPLING keep the electrical wiring away from the TUCK WASHER
and SAFETY CABLE.
THIS SAFETY CABLE IS REQUIRED ON ALL SINGLE CHAIN SUSPENDED CEILING FIXTURES WEIGHING
OVER 45 POUNDS. IMPROPER INSTALLATION OF THIS SAFETY CABLE COULD RESULT IN FIXTURE
FALLING OR SERIOUS INJURY. IF IN DOUBT ABOUT INSTALLATION, YOU MAY NEED TO CONSULT A
LICENSED ELECTRICIAN OR QUALIFIED CONTRACTOR.
OPTION ‘A’ (see FIGURE #1)
OPTION ‘B’ see FIGURE #2) (
SAFETY CABLE / TUCK WASHER INSTALLATION STEPS - See FIGURE #3
Work the SAFETY CABLE END through the FIXTURE CHAIN, alternating every other link. Proceed to pass
the SAFETY CABLE END through the NIPPLE, COUPLING and 3/8-18 PIPE . Make up the TUCK WASHER
KNOT, referring to Figure #3.
1) First, push all of the SAFETY CABLE up though the center hole.
2) Next, push the cable down through the 12 o’clock hole, leaving about ½”of slack.
3) Finally, push the cable up through the 1 o’clock hole and tuck it under the cable between the center hole
and the 12 o’clock holes.
4) For OPTION ‘A’: Pull all of excess cable through all of the holes until the TUCK WASHER is very close to
the opening at the end of the 3/8-18 NIPPLE. Remove as much slack as possible out of the TUCK WASHER.
About ½” of slack between TUCK WASHER and the hole is acceptable. (See FIGURE #1)
Pull the SAFETY CABLE through alternating links on the FIXTURE CHAIN and then through the NIPPLE. Pull
the SAFETY CABLE out of the of the COUPLING.
Make up a TUCK WASHER KNOT, referring to Figure#3.
small hole on the side (NOTE: SAFETY CABLE MUST NOT
EXIT COUPLING ON THE WIRE CONNECTION SIDE)
NOTE: THE SLACK IN THE SAFETY CABLE NEEDS TO BE LESS THAN THE SLACK IN THE SUPPLY WIRING.
SAFETY CABLE INSTALLATION INSTRUCTIONS
FIGURE #1
OPTION ‘A’
IS-TF1784
Page 3 of 3
Revised 2007-12-19
SAFETY CABLE
SAFETY CABLE
TUCK WASHER
SAFETY CABLE
TUCK WASHER
HEX
COUPLING
NIPPLE
FIXTURE CHAIN
WIRING
CONNECTIONS
QUICK-LINK
CONNECTOR