Quoizel KY1507IB Kyle - Manual (Page 3)

ASSEMBLY INSTRUCTIONS
3 OF 3
STEP 4:
a Screw the Mounting Screws into the Crossbar place the
Lock Washers over the Mounting Scr ews and thread the
Hex Nuts onto the Mounting Screws as shown
Secur e
the position of the Mounting Screws by tightening the Hex
Nuts against the Crossbar
b Secure the Crossbar to the Outlet Box with Outlet Box
Screws
. ,
.
.
.
.
Outlet Box
Crossbar
Mounting Screw
Hex Nut
Outlet Box Screw
Lock Washer
STEP 5 :
* ( ) .
.
.
( )
. ( )
( ) .
.
.
Use Wire Connectors not supplied to connect the wires
a Connect the House Ground Wire to the Fixtur e Ground
Wire.
b Connect the House White Wire to the Fixture Supply Wire
White or Ribbed Side .
c Connect the House Black or Red Wire to the Fixtur e
Supply Wire Black or Smooth Side
d Wrap each connection with approved electrical tape and
carefully stuff all of the connected wires into the Outlet
Box
WHITE WIRE
BLACK OR RED WIRE ( )
FROM HOUSE
GROUND WIRE GROUND WIRE
FROM HOUSE FROM FIXTURE
WHITE OR RIBBED
FROM FIXTURE FROM HOUSE
FROM FIXTURE
BLACK OR SMOOTH
STEP 6:
a Place the Ceiling Canopy over the Mounting Screws and
thread Mounting Balls onto the Mounting Screws to secure
it. Hand tighten until snug.
.
STEP 7:
a Locate the Shade inside of the Shade Holder Line up
Holes on the Shade and Mounting Holes on the Shade
Holder
Secure them together by threading Lock
Screws into the Mounting Holes on the Shade Holder
until the screws through the Holes on the S hade
. .
.
.
Outlet Box
Mounting Screw
Ceiling Canopy
Mounting Ball
Lock Screw
Shade
Hole
Shade Holder
Mounting Hole
STEP 8
.
:
a Install correct Bulb referring to fixture markings and/or labels for maximum wattage.
Your installation is completed now. Restore electricity. Retain this sheet for future reference.
STYLE NUMBER KY1507IB :