Dell PowerVault MD3260i - Manual (Page 18)

[-n storage-array-name | -w WWID | -h host-name |
-r (host_sa | direct_sa)] [-S]
SMcli -d [-w][-i][-s][-v][-S]
SMcli -m host-name-or-IP-address -F email-address
[-g contactInfoFile][-S]
SMcli -A [host-name-or-IP-address
[host-name-or-IP-address]] [-S]
SMcli -X (-n storage-array-name | -w WWID |
-h host-name)
SMcli -?
Command Line Parameters
Table 2. Command Line Parameters
Parameter Definition
host ‑name-or-IP-address Specify either the host name or the Internet Protocol (IP)
address of an in-band managed storage array (IPv4 or
IPv6) or an out-of-band managed storage array (IPv4 or
IPv6).
• If you manage a storage array by using a host
connected directly to the storage array (in ‑band
storage management), you must use the -n
parameter if more than one storage array is
connected to the host.
• If you manage a storage array through an Ethernet
connection (out-of-band storage management),
you must specify the host ‑name‑or‑IP‑address of
the redundant array of independent disks (RAID)
controller modules.
• If you have previously configured a storage array
in the graphical user interface (GUI) of the MD
Storage Manager, you can specify the storage
array by its user ‑supplied name by using the -n
parameter.
-A Use to add a storage array to the configuration files. If you
do not follow the -A parameter with a
host
‑name‑or‑IP‑address, automatic discovery scans the
local subnet for storage arrays.
-a Use to add an SNMP trap destination or an e-mail address
alert destination.
• When adding an SNMP trap destination, the
SNMP community is automatically defined as the
community name for the trap and the host is the IP
address or Domain Name Server (DNS) host name
of the system to which the trap should be sent.
• When adding an e-mail address for an alert
destination, the email-address is the e-mail
address to which to send the alert message.
18