Installing the system board – Dell PowerEdge T110 User Manual
Page 102
102
Installing System Components
CAUTION:
The processor and heat sink can become extremely hot. Allow
sufficient time for the processor and heat sink to cool before handling.
9 Remove the processor heat sink. See "Removing the Processor" on page 85.
10 Using a #2 Phillips screwdriver, remove the ten screws securing the system
board to the chassis and then slide the system board toward the front end
of the chassis.
CAUTION:
Do not lift the system board by grasping a memory module, processor,
or other components.
11 Grasp the system board by the edges of the system board and lift the
system board out of the chassis. See Figure 3-24.
Figure 3-24.
Removing and Installing the System Board
Installing the System Board
1 Unpack the new system board.
2 Remove the labels from the processor shield and affix them to the system
identification panel on the front of the system. See Figure 3-24.
1
screws (10)
2
system board
1
2
Mayzie_HOM.book Page 102 Monday, August 31, 2009 9:33 PM