Installing a redundant power supply, Figure 3-16, See "installing a – Dell PowerEdge T410 User Manual
Page 122
Advertising
122
Installing System Components
Figure 3-16.
Removing and Installing a Redundant Power Supply
Installing a Redundant Power Supply
1 Verify that both power supplies are the same type and have the same
maximum output power.
NOTE:
The maximum output power (shown in watts) is listed on the power
supply label.
2 If you are installing a power supply into an empty bay, remove the power
supply blank. See "Removing a Power Supply Blank" on page 123.
If you are installing a power supply into a bay that has a power supply,
see "Removing a Redundant Power Supply" on page 121.
1
power supply handle
2
velcro strap
3
release latch
1
2
3
book.book Page 122 Tuesday, June 9, 2009 4:09 PM
Advertising