Vermont Casting VC3624GS - Manual (Page 10)

Hardware:
Tools needed:
Assembly Step 5
Phillips Head
Screwdriver
1/2”
Wrench
1. For each damper plate, line it up with
the damper openings on the outside
of the smoker cabinet.
2. Insert a 10-24x5/8” bolt into the center
mounting hole from the outside of the
smoker.
3. From the inside of the smoker cabinet,
thread on a lock washer and nut.
Slightly tighten the nuts, but allow them
to stay loose enough to freely rotate the
damper plates.
4. For each carry handle, insert the
mounting studs into the mounting
holes on the sides of the smoker
cabinet.
5. From the inside of the smoker cabient,
thread on a nut onto each mounting
stud. Securely tighten the nuts.
There are 3 damper locations and 2 carry
handle locations - repeat steps until all are
assembled.
8
1/4-20 Nuts
4 Required
Locate these parts:
3 Damper Plates
2 Carry
Handles
HARDWARE BAG
B
10-24 Lock
Washers
3 Required
10-24 Nuts
3 Required
10-24x5/8” Bolts
3 Required
HARDWARE BAG
C