Qmark SED Series - Fan-Forced Wall Heaters - Manual

D Series
Fan Forced
Wall & Ceiling Heaters
Dear Owner,
Congratulations! Thank you for purchasing this Marley Engineered Products product. You have made a
wise investment selecting the highest quality product in the heating industry. Please carefully read the
installation and maintenance directions shown in this manual. You should enjoy years of efficient heat-
ing comfort with this product from Marley Engineered Products... the industry’s leader in design, manu-
facturing, quality and service.
... The Employees of
Marley Engineered Products
Read Carefully - These instructions are written to help
you prevent difficulties that might arise during installation.
Studying the instructions first may save you considerable
time and money later. Observe the following procedures,
and cut your installation time to a minimum. TO REDUCE
RISK OF FIRE OR ELECTRIC SHOCK:
1. Disconnect all power coming to heater at main service panel
before wiring or servicing.
2. All wiring must be in accordance with National and Local
Electrical Codes and the heater must be grounded.
3. Verify the power supply voltage coming to heater matches the
ratings printed on the heater nameplate before energizing.
4. This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces.
5. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock, fire,
or damage to the heater.
6. Do not block air intakes or exhaust in any manner. Keep com-
bustible materials, such as crates, drapes, etc., away from
heater. Do not install behind doors, furniture, towels, or
boxes. Do not install in ceiling at wattage greater than 1000.
7. A heater has hot and arcing or sparking parts inside. Do not
use it in areas where gasoline, paint, or flammable liquids are
used or stored.
8. Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
9. This heater is not approved for use in corrosive atmospheres
such as marine, green house, or chemical storage areas.
Installation & Maintenance Instructions
SAVE THESE INSTRUCTIONS
WARNING
1
!