Samson 12-STRAND Class I Eye Splice Modified for Quik-Splice - Manual

PAGE 1 OF 2
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
12-Strand Class I Eye Splice Modified for Quik-Splice
S A M S O N S P L I C I N G I N S T R U C T I O N S
1 fid
This is a modification to the standard 12-strand Class I eye splice
to be used for splicing Samson Quik-Splice.
The eye splice is used to place a permanent loop in the end of a
rope, generally for attachment purposes to a fixed point. An
eye is also used to form the rope around a thimble, which is
used to protect the rope, especially when it is to be attached
to a shackle, chain, or wire rope.
This eye splice may be performed on new or used rope.
This is an all-purpose splice technique designed for people
who generally splice used rope as frequently as new rope.
By following the procedure below, the splice can retain
from 90% to 100% of average new rope strength and,
in used rope, up to the same proportion of residual used
rope strength.
1
step
Tape end of line to be spliced and
measure 1 tubular fid length (or 2 wire
fid lengths because wire fids are half the
length of tubular fids) from taped end of
line and make Mark 1.
From Mark 1 measure 1 tubular fid
length (or 2 wire fid lengths) and make
Mark 2. Now form size of eye desired
and make Mark 3 adjacent to Mark 2.
Form size of
eye desired
Mark 3
Mark 2
1 fid
Finished splice
Mark 1
or
2 wire fids
M e a s u r i n g
3 strands (or pairs of strands), right then left,
pulled out and cut off
Mark 2 Mark 1
Retape end to
stop unbraiding
Splice, loop, etc.
2
step
From Mark 1, toward the taped end of the line, mark every second right and then every
second left strand* for 3 strands.** Pull every marked strand out of line and cut off
(tape at end can cause resistance and may have to be removed in order to pull out cut
strands.) Tapered end will now have only 6 strands remaining (or 4 strands for
an 8-strand braid.) Tape tapered tail tightly to keep from unbraiding.
step
3
Mark 3 Mark 4 fid Mark 1
2-1/2 fid
lengths
Tapered tail
Push
Measure 2-1/2 tubular fid lengths
(4 wire fid lengths), make Mark 4.
Insert fid and tapered tail at Mark
3 and push out beyond Mark 4.
M a k i n g ta p e r
B u ry i n g ta i l i n t o s ta n d i n g pa rt o f l i n e
*Some rope diameters may have pairs of strands in
right and left direction. In this case, treat the pairs
of strands as a single strand, marking and cutting
both in each direction as described above.
**Some very small diameter ropes may be 8-strand.
For an 8-strand construction, mark every 3rd left
and right strand for 2 strands.
Mark 2