Samson 12-STRAND Class II Tuck-Bury Eye Splice Modified for Saturn-12 - Manual

PAGE 1 OF 3
SamsonRope.com | Email [email protected] | Tel +1.360.384.4669
12-Strand Class II Tuck-Bury Eye Splice Modified for Saturn-12
S A M S O N S P L I C I N G I N S T R U C T I O N S
1
step
Tape end to be spliced. Then measure
2 fid lengths from the bitter end and
mark. This is Mark 1. Wrap tape tightly
around the rope at Mark 1.
1 A
From Mark 1, form a loop the
size of the eye desired and
mark. This is Mark 2.
1 B
From Mark 2, measure down
the rope 2-1/2 fid lengths and
mark. This is Mark 3.
2
step
At Mark 1, pull out half the strands (3
"S" and 3 "Z") by rotating around the
rope and pulling out strands in the
pattern shown:
Z strand = counter-clockwise twist
S strand = clockwise twist
This should leave 6 strands still
braided down the middle. Tightly tape
the ends of the 6 individual strands,
as well as the end of the remaining
braided portion.
On 1 side you should have 2 S strands
and 1 Z strand. On the other side, you
should have 2 Z strands and 1 S strand.
This is a modification to the standard HMPE Tuck-Bury 12-strand splice to increase splice length
on Saturn-12. This modification must be used on Saturn-12 products larger than 1-1/2" in diameter.
m e a s u r i n g a n d m a r K i n g
ta p e r i n g t h e ta i l
s
z
z
s
z
s
2-1/2 fids
2 fids
Form size of
eye desired
mark 1
mark 2
mark 3
Mark 1
Mark 1
mark 1
mark 1
mark 2 mark 3
Bitter end
At Mark 2, make a mark at the intersection of an S and a Z strand.
This will be the entry point for all 6 strands and the tail when it is
buried. The entry point should be on the side of the rope facing the
opposite leg of the eye.
From the entry point, count 2 picks down the rope and mark 6 strands
around the circumference of the rope. There will be 3 S strands and 3
Z strands marked. At each intersection of an S and a Z strand, mark
an exit point. There will be 6 exit points marked.
3
step
3 A
3 B
The first 3 strands are now routed from the entry point at Mark 2 to the exit point.
Each strand is routed separately, entering at the entry point and exiting at its own
exit point. Do not pull the strands up tight yet. Leave slack at the entry point.
r o u t i n g t h e s t r a n d s
mark 2
Entry point
Exit points
Standing rope
z
z
s
s
z
s
mark 1
mark 2
mark 3
marKing entry and exit points
routing 3 strands