Using the flash signal function – Nikon 58-104 User Manual
Page 54
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Using the Flash Signal Function
ii'
The flash signal function serves to
indicate your position in the sea
when resurfacing from under water.
1
Turn ON the SB-104’s power switch.
I
Slide the function selector to the
I Test position V and hold it
down for about four seconds.
—From the second firing, the flash will
repeat firing at 1 /32 output about every
two seconds.
—A fully-charged NiCd battery will let the
SB-104 continue firing in this mode about
3000 times (about one and a half hours).
I Turn OFF the power switch to stop.
54
Advertising
This manual is related to the following products: