Jeep 2011 Liberty - User Guide - Manual (Page 53)

Towing – Four-Wheel Drive
Models
• Depress the brake pedal and turn the
ignition switch to ON/RUN with the
engine shut off.
• Shift the transmission into NEUTRAL.
• Shift the transfer case into NEUTRAL
by holding down the NEUTRAL Pin
switch for four seconds until the LED
starts to blink. The LED will stop
blinking and remain on when the shift
is complete.
• Start the engine and shift into DRIVE
to ensure there is no vehicle
movement.
• Shut the engine off and shift the
transmission into PARK.
• Place the ignition switch in the OFF
position and remove the key.
• Apply the parking brake, attach the
vehicle to the tow vehicle with a tow
bar and release the parking brake.
• Refer to your Owner's Manual on the
DVD for further details.
CAUTION!
Towing with the rear wheels on the
ground (while the driveshaft is
connected) will cause severe
transmission damage. Damage from
improper towing is not covered under
the New Vehicle Limited Warranty.
WARNING!
• If the driveshaft is removed, the
vehicle can roll even if the
transmission is in PARK, which
could cause serious injury or
death.
UTILITY
51