Dual top — four-door models — if equipped, Removing the soft top — four-door models, Dual top — four-door models — if – Jeep 2013 Wrangler - Owner Manual User Manual

Page 200: Equipped, Removing the soft top — four-door, Models

Advertising
background image

NOTE:

Be sure the wire harness in the left rear corner is

not tangled in the soft top bows before you lift the top.

6. Unsnap and remove the black boot cover. This cover

should be discarded. It was intended as a protective
cover for shipping only.

NOTE:

A visual instruction sheet is enclosed in the dual

top wrap.

7. Put up the soft top. Refer to “Soft Top — Putting Up

The Soft Top” in this section.

DUAL TOP — FOUR-DOOR MODELS — IF
EQUIPPED

If your vehicle is equipped with a Dual Top, you must
remove one of the tops from the vehicle. If the soft top
is removed, the pivot brackets must also be removed
from the sport bar.

The soft top was installed at the

factory for shipping purposes only. The soft top and the
hard top are to be used independently.

Removal is

mandatory to prevent any possible wear and tear on the
soft top. Your vehicle warranty will not cover damage
resulting from both tops remaining on the vehicle at the
same time for extended periods of time.

Removing The Soft Top — Four-Door Models

1. Locate and remove the two boxes that contain the

following items:

• Right and left door frames
• Six door frame attachment knobs
• Right and left quarter windows
• Rear window
• Two rear window roll up straps
• Two Sunrider® secure straps (if equipped)
• Two rear swing gate brackets

198

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Advertising