Charging the receiver battery pack, Spektrum dx2e radio system, Installing the receiver battery in the battery box – Losi LOS04002 User Manual

Page 4: Installing the transmitter batteries

Advertising
background image

LOSI LST XXL 2 • INSTRUCTION MANUAL

4

EN

Dynamite 7.4V 2000mAh Li-Po receiver pack.

The Dynamite 2S Li-Po battery pack features a balancing lead that allows you
to safely charge your battery pack when used with a Li-Po balancing charger.

1. Remove the LiPo receiver battery pack from the battery box and disconnect the

red JST connector.

2. Connect the LiPo battery charger to an AC power outlet.
3. Refer to manufacturers battery charging directions.

Installing the Receiver Battery in the Battery Box

1. Connect the fully charged LiPo battery pack to the red JST connector

in the battery box.

2. Place the battery box cover on the battery box.

Charging the Receiver Battery Pack

1. Steering Wheel controls direction (left/right) of the model.
2. Throttle Trigger controls speed.
3. Antenna transmits the signal to the model.
4. ON/OFF Switch turns the power ON/OFF for the transmitter.
5. Indicator Lights

• Solid green light indicates adequate battery power.

• Flashing green light indicates the battery voltage is critically low. Replace batteries.

6. ST. Trim adjusts the “hands off” direction of the model.
7. TH. Trim adjusts the engine speed to idle at neutral.
8. ST. Rate Adjusts the AVC sensitivity.
9. BIND/R.O.S.S. button puts the transmitter into Bind Mode and starts or stops the engine

using R.O.S.S. (the LST XXL 2 does NOT use ROSS)

10. ST. REV reverses the function of the steering when the wheel is turned left or right.
11. TH. REV reverses the throttle control when pulled back or pushed forward.

Spektrum DX2E Radio System

For more information on the transmitter, go to www.spektrumrc.com and click on the support tab
to find the full manual for the DX2E transmitter.

Installing the Transmitter Batteries

1. Push in the battery cover a small amount

to release the retaining tab, then remove
the cover.

2. Install 4 AA batteries, taking care to align

battery polarity to the diagram in the
transmitter’s battery case.

3. Carefully reinstall the battery cover by

aligning the tabs with the slots on the
transmitter.

CAUTION: NEVER remove the transmitter batteries while the vehicle is powered on, as
loss of control, property damage or injury may result.

1

2

6

5

9

10

3

4

7

8

11

Advertising