QOMO Flow!Works 3.0 - Manual (Page 14)

14
5. You will be asked “Are you sure you want to remove Flow!Works and all of its
components?” Select “Yes”
6. When Flow!Works is successfully removed from your computer you will receive the
following message. Click “OK”.
Software Startup
There are three ways to launch QOMO HiteVision’s Flow!Works Software. They are:
1. Select the “Start” menu in the system, go to the program menu and select the “Flow!Works”
program.
2. Double click the program shortcut on your desktop.
3. Click and one of the shortcut keys on either side of the QOMO interactive whiteboard.
Software’s Offline Application
QOMO HiteVision’s Flow!Works Software can be used even when the computer is not
connected to a QOMO HiteVision product. You may prepare lessons with the Flow!Works
software on your own PC based on your needs.
In this case, the watermark shown in the figure below will appear on the writing board when
you start the software. The watermark will not influence the function of the program and will go
away when the PC or laptop is connected to a QOMO HiteVision product.
Watermark in Offline Slide of Lesson Preparation