Vintage Cellars VintageView Magnum Wall Mounted 18 Bottle Rack - Manual

MAG1 or MAG2 contains:
MAG1 and MAG2 Wall Mount
Wine Rack Instructions
Wine Master Cellars •10645 E 47th Ave, Denver, CO 80239 • phone: 866.650.1500 • fax: 866.650.1501
Please feel free to contact us regarding the assembly of this product.
Wine storage system
Tools Needed:
Before starting, open all Packaging for the MAG1 or MAG2 and take inventory to make sure you have everything.
• 1 Neck Strip • 2 Plastic Couplers
• 1 Spirit Level
• 1 Marking Pen or Pencil
• 1 Tape Measure
• 1 Screwdriver
• Drill and Drill Bits (Necessary in Some Cases)
There are three pre-drilled mounting holes in each strip, six total per rack. Appropriate fasteners must be utilized in every
mounting hole for proper installation. Fasteners are not included with your MAG1 or MAG2. However, we recommend the
following fasteners for these surfaces:
Fasteners:
• Wood Surface: #8 x 1-1/4” wood screw
• Drywall/Wallboard Surface: #8 x 1-1/4” screw with spiral inserts for the bottom two holes in each strip (4 total) and
an expanding hollow wall anchor such as a toggle bolt for the top hole in each strip (2 total)
• Concrete, Brick or Stucco: 3/16” x 1 ¾” masonry screw or #8 x 1 ¼” screw with appropriate size expanding anchor
NOTE: If you are attaching the MAG1 or MAG2 to a VintageView® Floor to Ceiling Frame (FCF) you will attach the
units to the FCF using the self-drilling screws included in the FCF packaging.
MAG1 and MAG2 Installation Instructions
1 - Determine which direction the bottle necks
should point.
• 1 Base Strip • 6 Rubber Mounting Hole Caps
1.1. If the bottle necks are to point to the right, the base
strip must be installed to the left of the neck strip.
1.2. If the bottle necks are to point to the left, the base
strip must be installed to the right of the neck strip.
2.1. The centerline of the first strip (either base or neck
depending on bottle neck direction) should be at least 3-1/4”
from adjacent walls or obstructions. This allows for the bottle
to overhang the rack.
2.2. From centerline of the first strip, measure 8-1/2” to the
centerline of the next strip.
Note: This dimension may be altered for specific bottle sizes.
If using the MAG1 or MAG2 racks for sparkling wines/Cham-
pagne, we recommend using 7-1/2” as a centerline-to-cen-
terline measurement between the neck and the base strips
.
2.3. (For multiple columns) locate the centerline of the next
strip 6” away from the prior strip.
2.4. (For multiple columns) continue marking the centerlines,
alternating between 8-1/2” (or 7-1/2” for sparkling wines/
Champagne) and 6” increments.
2 - Lay out the wall. (Fig. 1)
3 1/4"
8 1
/2"
8 1
/2"
6
1/
2"
Fig. 1