Vintage Cellars Silent 48 Bottle Double Door Dual Zone Wine Refrigerator - Manual (Page 6)

INSTALLATION INSTRUCTIONS
Before Using Your Wine Refrigerator
z
Remove any exterior and interior packing material.
z
Check to be sure the following parts are included:
‹
14 Slide out shelves.
‹
2 Handles and 4 Screws
‹
1 Instruction manual.
z
Before connecting the appliance to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
z
Clean the interior surface with lukewarm water using a soft cloth.
INSTALLING YOUR WINE REFRIGERATOR
z
Place your appliance on a floor that is strong enough to support the appliance when
it is fully loaded. To level your appliance, adjust the front legs at the bottom of the
appliance.
z
Keep away from direct sunlight and excess of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold or hot ambient temperature may also cause the
appliances not to perform properly.
z
This model is not meant to be built-in to cabinetry, recessed or put underneath a
counter. Additionally this model is not meant to be used in an enclosed area. While
the back of the unit does produce a minimal amount of heat, it still needs to vent to
an open area.
5