Vinten Radamec Quattro SE PDA - Manual (Page 18)

16 Quattro PDA Operators Guide
4. Adjust the position of the Quattro PDA on the pan bar handle so that camera operators can easily
view the PDA screen and access the functions using the stylus. Loosen the mounting arm adjustment
knob (2) and position the Quattro PDA, then tighten the knob to secure the PDA into the required
position.
Connecting the Quattro PDA to the HPM
The Quattro PDA is connected to the HPM that is mounted onto a bracket secured to the base of the
head. Using a combined power and data cable (5), the Quattro PDA communicates with the HPM and
is also powered by the HPM. When connected to a powered HPM, the Quattro PDA internal battery
is constantly being charged. There is no requirement to charge the PDA battery unless it has been
disconnected from the HPM and operated for several hours without an external power source (refer
to the PDA user documentation for instructions about recharging the PDA).
To connect the Quattro PDA to the HPM:
1. Connect the PDA serial connector to the Comms port on the Quattro PDA and then plug in the DC
power connector to the Power input socket. Refer to the PDA user documentation for Comms port
and power socket location.
2. Connect the HPM serial connector to the PDA Comms port on the HPM.
Powering Up
When the Quattro PDA has been installed, switch on the power to the Quattro SE pedestal, head and
HPM. Refer to the PDA user documentation for instructions on powering up the PDA.
NOTE: Mounting the Quattro PDA onto the pan bar handle will affect the fore
and aft balance of the head. Check the balance of the head after fitting
the Quattro PDA.
CAUTION! Switch off the power to the HPM, Quattro SE pedestal and the head
before connecting the Quattro PDA.
NOTE: The PDA cable has a single serial connector at one end that connects
to the HPM and a combination of serial connector and power plug at
the other end which connects to the PDA.